Sunday, 3 February 2008
Dave Weckl
Saturday, 2 February 2008
Swish cymbal
Zildjian swish cymbal
The swish cymbal and the pang cymbal are exotic ride cymbals originally developed as part of the collaboration between Gene Krupa and the Avedis Zildjian Company.
They have the upturned and flanged edge of a china cymbal with very small bell. The swish has a higher tone than the pang and is washier with a less pronounced ping, and this difference was accentuated as the swish was originally sold with rivets like a sizzle cymbal, while the pang was sold without rivets. However some drummers removed the rivets from the swish or added them to a pang. Typical sizes are 16 to 22 inches diameter for the swish, and 18 to 20 inches for the pang.
Sizzle cymbal
A sizzle cymbal is a cymbal to which rivets, chains or other rattles have been added to modify the sound.
These rattles have two main effects on the tone of the cymbal:
- Most obviously, the sound of the 'wash' of the cymbal is made louder and more penetrating, and is dominated by the sound of the rattles themselves.
- Also important but less obvious, the cymbal loses some of its sustain and dynamic range, because whenever there is insufficient energy left in the cymbal to lift the rattles the sound cuts out sharply.Both effects have musical uses, and can also be used to mask unwanted overtones in cymbals of lesser quality. However the best results are still generally obtained with high quality cymbals.
Many other rivet patterns have been tried, but the only one to have gained much following is a single cluster of three rivets close together in an arc close and parallel to the rim. This gained popularity in some genres during the late 1980s and early 1990s and was predicted to replace the traditional pattern, but the traditional pattern has remained more popular overall. Bottom hi-hats, crash cymbals, splash cymbals and even bell splashes have been fitted with rivets.
Some cymbal makers claim that if the rivets are removed from a sizzle cymbal its previous tone will be restored, despite the fact that this leaves small holes in the cymbal. Whether this is entirely true is controversial, with a result that the value of a cymbal is generally reduced by rivet holes. However it is also true that many classic cymbals from which rivets have been removed have excellent sounds despite the holes.
Two chain sizzlers
In order to produce a sizzle sound without the need to bore holes in the cymbal, sizzler' may be used. There are two main patterns:
- Rivet sizzlers suspend rivets above the rim of the cymbal, normally in two groups 180 degrees apart.
- Chain sizzlers suspend several short lengths of ball chain on the surface of the cymbal, most often either near the rim or more commonly in many places along a diameter. These chains may be fixed, adjustable in length, or completely removable. Sometimes a single chain of balls from a cabasa is used.
- Home-made sizzlers may be made at home with a coin and electrical tape. Take a 3 inch piece of electrical tape and place one end of it over a coin. With the rest of the tape, place it on a cymbal about 2 - 3 inches in from the outer edge, away from the playing area. When the cymbal is struck, the sizzle sound will ring for about 20 to 30 seconds, depending on the type of cymbal and the positioning of the sizzler.
When a sizzle cymbal is required in an orchestra, most often a chain sizzler is used. This allows the finest control and greatest range of tone in the hands of a skilled percussionist, and also allows any cymbal to be used without any permanent effect on its tone, giving still more tonal possibilities.